• CSKH: 0901.37.33.56 (Ms.Quỳnh) - 0912.124.679(Ms.Hoa)
  • Bộ nới tầm 30m System Sensor BEAMLRK

    Bộ nới tầm 30m System Sensor BEAMLRK

    Mã sản phẩm: System Sensor BEAMLRK Lượt xem: 838

    Mô tả sản phẩm:
    Bộ nới tầm Beam 30m System Sensor BEAMLRK
    Thông số kỷ thuật
    Xuất xứ: Trung Quốc

    Nhà sản xuất: System Sensor
    Mã sản phẩm: BEAMLRK
    Bảo hành 12 tháng.
    Liên hệ
    Xuất xứ
    Brand
     

    Mô tả chi tiết

    Bộ nồi tầm 30m System Sensor BEAMLRK
    The BEAMLRK allows reflected beam detectors to be installed at separations
    between 230 and 328 feet (70 to 100 meters). At these distances, four 8˝ ×
    8˝ reflectors must be used to provide enough reflected infrared light. This
    kit includes 3 additional reflectors with new test scale legends. The reflector
    included with the transmitter/receiver unit is the fourth reflector to be used.
    This kit is not compatible with the multi-mount kit (BEAMMMK).
    The kit includes the following parts:
    Qty. Description
    1 8˝ × 8˝ reflector (10% to 25% test scale)
    1 8˝ × 8˝ reflector (30% to 65% test scale)
    1 8˝ × 8˝ reflector (no test scale)
    MOUNTING INSTRUCTIONS
    1. Peel off the test scale sticker from the reflector included with the transmitter/receiver unit.
    2. Securely mount all four reflectors to the wall using all four screw holes
    on each reflector. (see Mounting Instructions section of the manual included with the transmitter/receiver unit for more details). The reflectors
    should be mounted as close to each other as possible. They should be
    mounted in a square pattern as indicated in Figure 1. The upper left
    reflector when viewed from the front should contain the lower test scale
    (10 to 25%). The upper right reflector should contain the higher test
    scale (30 to 65%). The bottom reflectors do not have a scale on them.
    3. Complete the installation of the transmitter/receiver unit using the instructions included with the beam detector.
    4. Test the system as indicated in the beam detector instructions. (see “Sensitivity Testing” section of the transmitter/receiver instructions).

    Đánh giá

    Bình luận

    Bạn đã không sử dụng Site, Bấm vào đây để duy trì trạng thái đăng nhập. Thời gian chờ: 60 giây